2. Ecofloor™ by demista™ Ltd

Space for imagination

Easy to install single end connection
Low running costs
Completely safe. CE compliant
Easily controlled via room thermostat (supplied)
Maintenance free
10 year warranty
Reduces condensation
Minimises dust and air movement
Frees up wall and floor space needed by conventional heating systems

Kit includes:

Drum mounted, thin double insulated and earth screened heating cable fitted with 3m long cold connection lead.

Twin conductor, 3mm overall thick cable requiring connection from one end only.

Template to plan cable runs.

12 amp switched electronic thermostat with remote floor sensor probe and flexible protective tube (can be reset to provide ambient room temperature control or dual function).

Optional 16 amp combined electronic programmable thermostat.

High impact adhesive fixing tape.

Extension length cables available as ADSLIP twin conductor, earth screened cable on drums.

Full installation instructions. Manufacture’s guarantee.

Sizing Guide

Select heating level required
A 160 w/m² B 130 w/m² C 100 w/m²

Calculate the total useable room floor area with allowance to avoid fixed furniture such as kitchen units and bathroom sanitary fitments.

Select the nearest size kit below useable area. Example: background heating to a free floor area of 8.0m² Type 10750 (7.5m²) – 750 Watts.

The kit can be installed to give outputs of:

A 160 W/m² for optimum heating output

B 130 W/m² for comfort heating

C 100 W/m² for background heating (recommended for laying under timber floors)

Have a fully qualified electrician check final resistances and make sure wire has not been damaged by covering the floor finish.

Make a note of final readings and store them in a safe place adjacent to the distribution board.

The ECOFLOOR™ cable is covered by a 10-year manufacturers warranty provided that it has been installed strictly in accordance with installation instructions and all necessary electrical regulations. The thermostat is covered by a 1-year manufactures warranty.

Care should be taken not to thermally block any part of the heated floor as this could result in localised overheating and possible damage to the surface.

« Back to the demista™ Ltd page